Connecting S0 to WiFi

Since S0 is based on ESP32-C6 which has WiFi capabilities, it can be configured in Station Mode or Access Point Mode.

Ensure you are in the embedded/targets/zephyr/m0-wifi directory.

Access Point Mode

To configure the S0 as an access point, configure the parameters in src/config.h to your preference.

Set parameters like WIFI_AP_SSID and WIFI_AP_PSK to your preference:

/* AP Mode Configuration */
#define WIFI_AP_SSID       "M0-AP"
#define WIFI_AP_PSK        ""
#define WIFI_AP_IP_ADDRESS "192.168.4.1"
#define WIFI_AP_NETMASK    "255.255.255.0"

Station Mode

To configure S0 in station mode, configure the WiFi SSID and password in src/config.h:

/* STA Mode Configuration */
#define WIFI_SSID "SSID"     /* Replace `SSID` with WiFi ssid. */
#define WIFI_PSK  "PASSWORD" /* Replace `PASSWORD` with Router password. */

Building and Flashing Code

Build the code and upload it to S0:

west build -p always -b esp32c6_devkitc
west flash
west espressif monitor

See the logs from the Serial Monitor to check whether S0 is connected.